Thus the three basic bipolar transistor circuit configurations have equivalents with a FET; common-emitter becomes common-source, common-base becomes common-gate, and an emitter follower becomes a ...

Researchers have reported a black phosphorus transistor that can be used as an alternative ultra-low power switch. A research team developed a thickness-controlled black phosphorous tunnel field ...

Tunnelling transistor offers logic and power on the same easy-to-make IC Only eight lithography masks to create a low-power custom logic chips, compared with 20+ for CMOS, is the claim of ...

This enables the realization of a very low power circuit in which the transistor is Normally-On but not saturated, and is controlled by an isolated tunnel connection, rather than a direct metal ...

You’ll need to reduce the input drive down to 50mV, but even then the output from the original circuit will be very disappointing. Of course, Q2 is going to need to be a power transistor.

Power input should be 9 to 12Vdc, with a maximum of 15V.On-board voltage regulators create +5V for the logic circuit and +6.5V for the gate driver. The 30A/55m? GS66508T GaN power transistors are ...

One transistor by itself is interesting, but the true power of the transistor shows itself when we put a ton of them together. This is where integrated circuits (ICs) and microchips enter the picture.

The circuit acts like an efficient diode. With Enable low, the hot-swappable side has no effect on the signal, with or without power applied. The two-transistor circuit offers the additional benefit ...

Because of on-going intellectual property protection, Longobardi could not discuss details of the company’s technology, but did reveal that it takes an integrated circuit approach, building extra GaN ...

They cannot be used for accurate transistor-level power analysis, power sequence analysis, and mixed-signal timing analysis because they cannot accurately model the analog circuitry and device-level ...