Figure 1 A Flip ON Flop OFF circuit for DC voltages. The gadget is connected to the output terminals of the PB. With an adequate heat sink for MOSFET Q1, the output current can go up to 50 A. During ...

A flip-flop is one of the most basic digital electronic circuits. It can most easily be built from just two transistors, although they can and have been built out of vacuum tubes, NAND and NOR gate… ...

One flip flop failing on an FPGA without radiation or some other specific reason isn’t very likely. And if you need radiation tolerance, just doing the flip flops might not be enough.

In this paper, the authors deal with the testable design of conservative logic based sequential circuits by using two test vectors. The conservative logic based sequential circuits are built from ...

Figure 1 Flip ON/Flop OFF referenced to the V+ rail. If V+ < 15v, then set R4 = 0 and omit C2 and Z1. Ensure that C2’s voltage rating is > (V+ – 15v) and if V+ > 80v, R4 > 4V+ 2 Figure 1 returns to an ...

One set of contacts (pins 2, 3, and 4) are used to steer the flip-flop, and the other set (7, 8, and 9) are available for the end application. In the state shown, C1 has charged to 5 V through R1.

One set of contacts (pins 2, 3, and 4) are used to steer the flip-flop, and the other set (7, 8, and 9) are available for the end application. In the state shown, C1 has charged to 5 V through R1.