Makers, developers and Arduino enthusiasts searching for silent stepper drivers with high resolution encoders which are also Arduino compatible. May be interested in the new range of uStepper S ...

grbl is stepper motor controller firmware for three-axis cnc machines, intended to run on Arduinos with a motor driver add-on board. Engineer in Wonderland cnc-related blogs are indexed here It is the ...

He was able to get it running with an Arduino in no time so he decided to take the project a little bit further. What he ended up with is a stepper motor driver which can be controlled over Bluetooth.

Even first-time users can get a stepper motor moving as commanded in 30 min or less. Commands can be issued from any serial terminal program or from the EZ Stepper Windows program, but the EZHR17EN ...

Some might complain that the 3+Pi doesn’t allow for easily swapping out the stepper drivers if you manage to cook one like on the Arduino CNC shield, but realistically you could say the same ...

Toshiba has launched an 4 x 4mm QFN24 stepper motor driver that can run from 4.5 to 33V and deliver up to 1.2A. Typical on-resistance of the output block is 1.2Ω. “It is well suited for ...

This Design Idea further develops a previous one integrating a stepper-motor driver in a CPLD (Reference 1 ). However, this idea integrates not only the driver, but also a simple one-axis ...

Next is the verified circuit diagram of the L9110 dual-motor driver module that I bought from RhydoLabz (India). Unlike most other DC motor driver modules, this module has a single VCC for both ...